Parent page: Schematic Commands
The following pre-packaged resource, derived from this base command, is available:
Applied Parameters: None
This command is used to place a Round Rectangle object onto the active document. A round rectangle is a non-electrical drawing primitive. Essentially a rectangle object with rounded corners, it is a graphic element that can be placed on a schematic sheet – filled or unfilled.
Round rectangles are available for placement in both Schematic and Schematic Library Editors:
After launching the command, the cursor will change to a cross-hair and you will enter round rectangle placement mode. Placement is made by performing the following sequence of actions:
Additional actions that can be performed during placement – while the round rectangle is still floating on the cursor, and before its first corner is anchored – are: