Altium Designer Documentation

SynchronizeHierarchy

Created: August 4, 2017 | Updated: August 4, 2017

Parent page: Schematic Commands

The following pre-packaged resources, derived from this base command, are available:


Applied Parameters: Action=WholeProject

Summary

This command is used to synchronize the sheet entries and sub-sheet ports for all sheet symbols in the active project.

Access

This command is accessed in the Schematic Editor, by choosing the Design » Synchronize Sheet Entries and Ports command from the main menus. There is no need to select any sheet symbols prior to launching this command.

Use

After launching the command, the Synchronize Ports To Sheet Entries dialog will appear. A separate tab is presented for each sheet symbol in the design. Use the dialog to ensure that all sheet entries on a sheet symbol, are matched to ports on the referenced child sheet below. A sheet symbol is said to be 'synchronized' with its referenced child sheet if all of its sheet entries match the corresponding ports on that sub-sheet – both by Name and I/O Type.

Tips

  1. Note that any changes made in the dialog take effect immediately. A change cannot be undone through the dialog. You will need to use the document's Undo feature to unwind a change.


Applied Parameters: ContextSensitive=True|Action=SingleSheetSymbol|ObjectKind=SheetSymbol

Summary

This command is used to synchronize the sheet entries and sub-sheet ports for the sheet symbol currently under the cursor.

Access

This command is accessed in the Schematic Editor, by right-clicking over the required sheet symbol, and choosing the Sheet Symbol Actions » Synchronize Sheet Entries and Ports command from the context menu. There is no need to select the sheet symbol first.

Use

After launching the command, the Synchronize Ports To Sheet Entries dialog will appear, with a single tab presented for the sheet symbol under the cursor. Use the dialog to ensure that all sheet entries on the sheet symbol, are matched to ports on the referenced child sheet below. A sheet symbol is said to be 'synchronized' with its referenced child sheet if all of its sheet entries match the corresponding ports on that sub-sheet – both by Name and I/O Type.

Tips

  1. Note that any changes made in the dialog take effect immediately. A change cannot be undone through the dialog. You will need to use the document's Undo feature to unwind a change.

 

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

联系我们

联系原厂或当地办公室

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: