PCB_Cmd-RemoveCoverlayRegionRemoveCoverlayRegion_AD

Created: January 14, 2021 | Updated: January 22, 2021

Applies to Altium NEXUS Client versions: 4 and 5

This documentation page references Altium NEXUS/NEXUS Client (part of the deployed NEXUS solution), which has been discontinued. All your PCB design, data management and collaboration needs can now be delivered by Altium Designer (with Altium Designer Enterprise Subscription) and a connected Altium 365 Workspace. Check out the FAQs page for more information.

Parent page: PCB Commands

The following pre-packaged resources, derived from this base command, are available:

Remove Coverlay Region

Applied Parameters: None

Summary

This command is used to remove a coverlay region.

Access

The command is accessed from the PCB editor in Board Planning Mode by right-clicking over a Flex coverlay region then choosing Coverlay Actions » Remove Coverlay. The required coverlay layer must be the active layer in the main design space.

The current viewing mode for the PCB document can be changed using the corresponding commands from the main View menu. To switch to Board Planning Mode, use the command of the same name, or use the 1 keyboard shortcut.

Use

First, ensure that a coverlay region is present on the PCB. After launching the command, the coverlay region will be removed.

Printer-friendly version

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Summary

Access

Use

Contact Us