Altium NEXUS Documentation

PCB_Cmd-SetOriginSetOrigin_AD

Created: June 21, 2017 | Updated: July 17, 2018
This documentation page references Altium NEXUS/NEXUS Client (part of the deployed NEXUS solution), which has been discontinued. All your PCB design, data management and collaboration needs can now be delivered by Altium Designer (with Altium Designer Enterprise Subscription) and a connected Altium 365 Workspace. Check out the FAQs page for more information.

Parent page: PCB Commands

The following pre-packaged resource, derived from this base command, is available:


Applied Parameters: None

Summary

This command is used to define a location in the workspace as the new (relative) origin and sets its coordinates to (0,0).

Access

This command can be accessed from the PCB Editor by:

  • Choosing the Edit » Origin » Set command from the main menus.
  • Clicking the  button on the Utility Tools drop-down () of the Utilities toolbar.

Use

After launching the command, the cursor will change to a crosshair and you will be prompted to select the new relative origin. Position the cursor at the required location in the workspace then click or press Enter. This point will be set to coordinate (0, 0) and all objects in the workspace will have their locations updated relative to this point.

Tips

  1. To set the relative origin back to the default absolute origin at the extreme lower-left of the document workspace, use the Edit » Origin » Reset command from the main menus.

 

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: