Altium NEXUS Documentation

OutlineSelectedObjects

Created: July 27, 2015 | Updated: July 13, 2018

Parent page: PCB Commands

The following pre-packaged resource, derived from this base command, is available:


Applied Parameters: None

Summary

This command is used to place an outline of tracks and arcs around selected free primitives in the design. This feature can be particularly useful if you want to electrically isolate critical nets by tying the outline to a ground source.

Access

This command is accessed from the PCB Editor by choosing the Tools » Outline Selected Objects command from the main menus.

Use

First, ensure that the objects you wish to outline are selected in the main design window.

After launching the command, the objects will be outlined with tracks and/or arcs. The outline tracks/arcs are placed with a width of 8mil and the Net property set to No Net.

Tips

  1. Clearance, Width and Short-Circuit design rules for the design are observed, so clearance violations will be flagged by the Design Rule Checker.

 

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: