Altium Designer Documentation

RoundCoords

Created: 27.07.2015 | Updated: 09.06.2017

Parent page: Schematic Commands

The following pre-packaged resource, derived from this base command, is available:


Applied Parameters: None

Summary

This command is used to round up the internal coordinates of objects, to counter any rounding effect when switching from Imperial to Metric measurement units mid-design. The overall result is that the internal coordinates of all design objects will be as they would have been, had you started designing with metric units from the outset.

Access

This command is accessed from the Schematic Editor by choosing the Tools » Convert » Round coordinates of objects command, from the main menus.

Use

After launching the command, the Rounding coordinates of objects dialog will appear. Use this dialog to define which documents the rounding process will be applied to - either the current document only, all schematic documents in the current (active) project, or all open schematic documents (irrespective of the project they belong to) - then click OK. An information dialog will summarize how many objects, on how many documents, had their coordinates rounded.

 

Обнаружили проблему в этом документе? Выделите область и нажмите Ctrl+Enter, чтобы оповестить нас.

Связаться с нами

Связаться с нашими Представительствами напрямую

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
Вы сообщаете о проблеме, связанной со следующим выделенным текстом
и/или изображением в активном документе: