Altium NEXUS Documentation


Created: July 7, 2022 | Updated: July 7, 2022
Applies to Altium NEXUS Client version: 5
This documentation page references Altium NEXUS/NEXUS Client (part of the deployed NEXUS solution), which has been discontinued. All your PCB design, data management and collaboration needs can now be delivered by Altium Designer (with Altium Designer Enterprise Subscription) and a connected Altium 365 Workspace. Check out the FAQs page for more information.

Parent page: Schematic Commands

The following pre-packaged resource, derived from this base command, is available:

Applied Parameters: None


This command is used to search the current document for user-specified errors, such as duplicate pin numbers or missing footprints.


This command is accessed from the Schematic Library Editor by choosing the Reports » Component Rule Check command from the main menus.


After launching the command, the Library Component Rule Check dialog opens. Use this dialog to set the attributes for which you want to test. After clicking OK, a report is generated (LibraryName.ERR) and opened as the active document. Each component that is found to be in error is listed along with the specific tests that it failed.


  1. The report is stored in the same location as the library document and is added to the Projects panel as a free document under the Documentation\Text Documents sub-folder.
  2. When checking for duplicate pins, only the first instance will be reported for each component. If more than one duplicate exists, this will not be reported separately.


Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: