Altium NEXUS Documentation


Created: July 27, 2015 | Updated: April 11, 2017
This documentation page references Altium NEXUS/NEXUS Client (part of the deployed NEXUS solution), which has been discontinued. All your PCB design, data management and collaboration needs can now be delivered by Altium Designer (with Altium Designer Enterprise Subscription) and a connected Altium 365 Workspace. Check out the FAQs page for more information.

Parent page: Schematic Commands

The following pre-packaged resource, derived from this base command, is available:

Applied Parameters: LocationMark=n (where n is in the range 1 to 10)


This command is used to store the coordinates of a position in the current document, as defined by the user, in the nth location marker. This position can be accessed quickly by using the corresponding Jump Location Mark n command.


This command is accessed from the Schematic Editor by choosing the Edit » Jump » Set Location Marks » n command, from the main menus.


After launching the command, the cursor will change to a crosshair. Simply position the cursor at the point in the workspace that you wish to create a marker and click. The coordinates of this position will be stored in the nth location marker.


  1. A new position assigned to the location marker will overwrite a previously defined position.
  2. The stored location is only available while the schematic document remains open (active or not). If the document is closed and opened again, the location marker will be empty.


Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: