Altium NEXUS Documentation


Created: June 6, 2017 | Updated: June 6, 2017
Applies to Altium NEXUS Client versions: 1.0, 1.1, 2.0, 2.1, 3.0, 3.1, 3.2, 4 and 5
This documentation page references Altium NEXUS/NEXUS Client (part of the deployed NEXUS solution), which has been discontinued. All your PCB design, data management and collaboration needs can now be delivered by Altium Designer (with Altium Designer Enterprise Subscription) and a connected Altium 365 Workspace. Check out the FAQs page for more information.

Parent page: Schematic Commands

The following pre-packaged resource, derived from this base command, is available:

Applied Parameters: None


This command is used to quickly convert a 4-way auto-generated junction (created with wire or bus objects), into two adjacent 3-way auto-generated junctions.


This command is accessed in the Schematic Editor only, by choosing the Tools » Convert » Convert Cross Junctions command from the main menus.


After launching the command, the Junctions Conversion dialog will appear. Use this dialog to determine the scope of the conversion (current document, project documents, or all open schematic documents), and whether all potential 4-way junctions are considered, or only those associated to selected wires/busses in the target documents. Once conversion options are configured as desired, clicking OK in the dialog will effect conversion.


  1. When converting based on selected objects, you must select all wire (or bus) segments that enter the 4-way junction.


Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: