Parent page: Schematic Commands
The following pre-packaged resource, derived from this base command, is available:
Applied Parameters: None
This command is used to place a Rectangle object onto the active document. A rectangle is a non-electrical drawing primitive. It is a graphic element that can be placed on a schematic sheet and can be filled or unfilled.
Rectangles are available for placement in both Schematic and Schematic Library Editors:
After launching the command, the cursor will change to a cross-hair and you will enter rectangle placement mode. Placement is made by performing the following sequence of actions:
Additional actions that can be performed during placement – while the rectangle is still floating on the cursor, and before its first corner is anchored – are:
Contact our corporate or local offices directly.