Altium NEXUS Documentation


Created: July 7, 2022 | Updated: July 7, 2022
Applies to Altium NEXUS Client version: 5
This documentation page references Altium NEXUS/NEXUS Client (part of the deployed NEXUS solution), which has been discontinued. All your PCB design, data management and collaboration needs can now be delivered by Altium Designer (with Altium Designer Enterprise Subscription) and a connected Altium 365 Workspace. Check out the FAQs page for more information.

Parent page: Schematic Commands

The following pre-packaged resource, derived from this base command, is available:

Applied Parameters: None


This command is used to turn the cursor electrical grid on or off.


This command can be accessed from the Schematic Editor by:

  • Choosing the View » Grids » Toggle Electrical Grid command, from the main menus.
  • Choosing the Toggle Electrical Grid command, on the Grids drop-down () of the Utilities toolbar.
  • Using the Shift+E keyboard shortcut.


The electrical grid is a special grid designed to assist you in wiring up your schematic. The electrical grid defines a range around electrical objects within which the cursor is "captured" by the object, overriding the current snap grid.

Wires, part pins, etc, are all affected by the electrical grid. With the electrical grid turned on, as you wire up your schematic, the cursor will automatically "find" electrical hot spots, making it easier to connect to electrical objects.

Launch the command to toggle the electrical grid status on or off.


  1. The electrical grid for the currently active schematic sheet can also be enabled/disabled when configuring Document Options through the Properties panel (when no objects are selected in the workspace). Simply enable/disable the Snap option (in the General section of the panel).


Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: