Altium NEXUS Documentation


Created: September 27, 2017 | Updated: September 27, 2017

Parent page: Schematic Commands

The following pre-packaged resource, derived from this base command, is available:

Applied Parameters: None


This command allows you to reverse the order that selected sheet entries appear along a side of a parent sheet symbol.


This command can be accessed from the Schematic Editor by:

  • Choosing the Edit » Move » Reverse Selected Sheet Entries Order command, from the main menus.
  • Locating and using the Reverse Selected Sheet Entries Order command () on the Active Bar.
If the command has been recently used from the Active Bar, it will become the active/visible button. Where other commands are available, this is indicated by a triangle at the bottom-right corner of the button. Click and hold on the active button to access a menu of all associated commands for that grouping.


First ensure that all sheet entries that you wish to reorder are selected prior to launching the command. Two or more sheet entries must be selected for a particular side of a sheet symbol, in order for the command to have effect. You can simultaneously reorder sheet entries along different sides of the same parent sheet symbol, and across different sheet symbols on the active schematic sheet.

After launching the command, the reordering will take place. The reordering is achieved by mirroring the positions of the selected sheet entries - along a particular sheet symbol side - about an imaginary line at the mid point of the distance between the extents of the two outer-most selected sheet entries.


  1. The I/O Type of a sheet entry is not changed by the reordering.


Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: