Altium NEXUS Documentation


Created: September 27, 2017 | Updated: September 27, 2017
Applies to Altium NEXUS Client versions: 1.0, 1.1, 2.0, 2.1, 3.0, 3.1, 3.2, 4 and 5
This documentation page references Altium NEXUS/NEXUS Client (part of the deployed NEXUS solution), which has been discontinued. All your PCB design, data management and collaboration needs can now be delivered by Altium Designer (with Altium Designer Enterprise Subscription) and a connected Altium 365 Workspace. Check out the FAQs page for more information.

Parent page: Schematic Commands

The following pre-packaged resource, derived from this base command, is available:

Applied Parameters: None


This command is used to move one object behind another object in a stack of overlapping objects. The Schematic Editor/Schematic Library Editor automatically stacks objects, text and graphics in layers. Each object is on a different layer depending on the creation order and therefore it is possible to place objects so that they overlap. The objects created or added recently are always on the top layer.


This command can be accessed from the Schematic Editor and the Schematic Library Editor, by:

  • Choosing the Edit » Move » Send To Back Of command, from the main menus.
  • Locating and using the Send To Back Of command () on the Active Bar.
If the command has been recently used from the Active Bar, it will become the active/visible button. Where other commands are available, this is indicated by a triangle at the bottom-right corner of the button. Click and hold on the active button to access a menu of all associated commands for that grouping.


After launching the command, the cursor will change to a crosshair and you will be prompted to choose an object to move. Simply position the cursor over the object that you want to move and click or press Enter. You will then be prompted to choose an object that you wish to move the first object behind. Position the cursor over this 'target' object and click or press Enter. The first object will be moved behind this target object, without changing its x or y coordinates.

Continue moving further objects, or right-click, or press Esc, to exit movement mode.


  1. When selecting the initial or target objects, if you click on an area where multiple possible objects overlap, a pop-up will appear containing all overlapping objects from which to make your choice.


Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: