PCB_Dlg-Reconnect_OptionsFormSubnet Connector_AD
Created: сентября 07, 2016 | Updated: июня 18, 2017
| Applies to versions: 17.0 and 17.1
Вы просматриваете версию 17.1. Для самой новой информации, перейдите на страницу PCB_Dlg-Reconnect_OptionsForm((Subnet Connector))_AD для версии 22
The Subnet Connector dialog.
Summary
This dialog allows the designer to specify the maximum subnet separation.
Access
From the toolbar in the PCB Editor, select Route » Auto Route » Add Subnet Jumpers.
Options/Controls
- Maximum Subnet Separation - Enter a value for the maximum subnet separation (100mil is the default value) of incomplete routing segments.
- Run - Click to automatically add subnet connectors to complete short routing segments (tracks that still have connection lines in between) on the current PCB document.
Click Cancel to exit the dialog without saving changes.
