Altium Designer Documentation


Created: 29.02.2016 | Updated: 30.04.2020
Вы просматриваете версию 21. Для самой новой информации, перейдите на страницу для версии 22

Parent page: PCB Commands

The following pre-packaged resource, derived from this base command, is available:

Applied Parameters: Object=Board


This command is used to move the entire board - the board shape, plus all design objects within that shape - to another position in the current document.


This command can be accessed from the PCB Editor when configured in Board Planning Mode by choosing the Design » Move Board command from the main menus.

The current viewing mode for the PCB document can be changed using the corresponding commands from the main View menu. To switch to Board Planning Mode, use the command of the same name or use the 1 keyboard shortcut.


After launching the command, an outline copy of the board shape will be attached to the cursor, held by its bottom-left corner. Move the shape to the desired new location within the workspace then click or press Enter to effect placement. All constituent design objects will be moved also to maintain position within the board shape.

To cancel without moving, right-click or press Esc.


Обнаружили проблему в этом документе? Выделите область и нажмите Ctrl+Enter, чтобы оповестить нас.

Связаться с нами

Связаться с нашими Представительствами напрямую

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
Вы сообщаете о проблеме, связанной со следующим выделенным текстом
и/или изображением в активном документе: