Altium Designer Documentation


Created: 02.08.2017 | Updated: 17.07.2018
Вы просматриваете версию 21. Для самой новой информации, перейдите на страницу для версии 22

Parent page: PCB Commands

The following pre-packaged resources, derived from this base command, are available:

Applied Parameters: RunRuleWizard=True


This command is used to run the Design Rule Wizard, from where you will be guided, step-by-step, through the process of creating a new design rule.


This command is accessed from the PCB Editor by choosing the Design » Rule Wizard command from the main menus.


After launching the command, the Design Rule Wizard will open. Use the pages of the Wizard to create a new design rule. Steps involve:

  1. Choosing the required rule type and giving it a meaningful name (and comment if required).
  2. Defining the scope of the rule. You will have the opportunity to further enhance scoping through an incarnation of the Query Builder that is built into the Wizard.
  3. Setting the rule priority.

If the Launch main design rules dialog option is enabled on the last page of the Wizard, the PCB Rules and Constraints Editor dialog will open upon clicking the Finish button. This dialog can be used to edit the constraints for your newly-created rule.


  1. The Query Builder is often used wherever there is a need to construct logical query expressions. It is a simpler method of constructing a query, using sensitive condition types and values that only allow a query to be constructed using relevant 'building blocks'. For advanced query construction, with full keyword specification and operator syntax, use the Query Helper, which is available as part of the scoping controls for a rule in the PCB Rules and Constraints Editor dialog.


Обнаружили проблему в этом документе? Выделите область и нажмите Ctrl+Enter, чтобы оповестить нас.

Связаться с нами

Связаться с нашими Представительствами напрямую

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
Вы сообщаете о проблеме, связанной со следующим выделенным текстом
и/или изображением в активном документе: