Altium NEXUS Documentation


Created: June 10, 2016 | Updated: April 11, 2017

Parent page: CAMtastic Commands

The following pre-packaged resource, derived from this base command, is available:

Applied Parameters: CommandMode=NC


This command is used to toggle the display of drill symbols in the current document. Drill symbols are used as a visual aid for easily locating drill points. A drill symbol appears as a white cross, marking the center of the drill point.


This command is accessed from the CAMtastic Editor by choosing the View » Display Symbols » Drill command from the main menus.


After launching the command, the display of drill symbols on the current document will either be enabled or disabled, depending on their current display status.


  1. In order for this command to be available, make sure that you are in the NC Editor, rather than the CAM Editor. Editor selection is carried out from the View menu.


Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: