Altium NEXUS Documentation


Created: June 11, 2016 | Updated: April 11, 2017
Applies to Altium NEXUS Client versions: 1.0, 1.1, 2.0, 2.1, 3.0, 3.1, 3.2, 4 and 5
This documentation page references Altium NEXUS/NEXUS Client (part of the deployed NEXUS solution), which has been discontinued. All your PCB design, data management and collaboration needs can now be delivered by Altium Designer (with Altium Designer Enterprise Subscription) and a connected Altium 365 Workspace. Check out the FAQs page for more information.

Parent page: CAMtastic Commands

The following pre-packaged resource, derived from this base command, is available:

Applied Parameters: CommandMode=NC


This command is used to redraw the information on the current drill layer, at a user-defined speed, so that you can see the order in which the drilling machine will proceed to drill your design.


This command is accessed from the CAMtastic Editor by choosing the Tables » Layers Order command from the main menus.


First, ensure that you have the drill layer selected as the only visible layer in the main design workspace. After launching the command, the Animate Viewing dialog will appear. Use this dialog to define the redraw speed for the layer. Choose from a predefined range of speed values - the larger the value, the slower the redraw speed.

After clicking OK, the current drill layer will be redrawn using the selected speed. The drill points will be redrawn in the order in which they will be drilled by the actual drilling machine.


Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: