Altium NEXUS Documentation

SelmenuDisplay

Created: June 11, 2016 | Updated: April 11, 2017

Parent page: CAMtastic Commands

The following pre-packaged resource, derived from this base command, is available:


Applied Parameters: None

Summary

This command is used to select all objects that are currently visible in the main design window.

Access

This command can be accessed from the CAMtastic Editor by:

  • Choosing the Edit » Selection » Display command from the main menus.
  • Clicking the  button, on the Miscellaneous Tools drop-down () of the Utilities toolbar.

Use

After launching the command, all objects that are displayed within the bounds of the main display window will become selected.

Tips

  1. You must be in editing mode (carrying out an editing operation), before this command will become available.
  2. Objects will only be selected if the Add selection mode is enabled.
  3. Using this command on an existing selection, and with the Remove selection mode enabled, will cause all objects in the visible display area to become deselected.
  4. The objects added/removed will depend on the selection modes enabled - Flash/Point and/or Draws.

 

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: