Altium NEXUS Documentation


Created: June 10, 2016 | Updated: April 11, 2017
Applies to Altium NEXUS Client versions: 1.0, 1.1, 2.0, 2.1, 3.0, 3.1, 3.2, 4 and 5
This documentation page references Altium NEXUS/NEXUS Client (part of the deployed NEXUS solution), which has been discontinued. All your PCB design, data management and collaboration needs can now be delivered by Altium Designer (with Altium Designer Enterprise Subscription) and a connected Altium 365 Workspace. Check out the FAQs page for more information.

Parent page: CAMtastic Commands

The following pre-packaged resource, derived from this base command, is available:

Applied Parameters: None


This command is used to reunite the constituent layers of a composite layer, that has been previously opened for layer-level editing.


This command is accessed from the CAMtastic Editor by choosing the Edit » Composite Layers » Close Composite command from the main menus.


After launching the command, the composite layer that you have opened for performing layer-level changes will be closed. The constituent layers will be re-merged and the original composite layer will be available in the layers list of the CAMtastic panel.


  1. Use of this command will only apply to the last composite layer you have opened. If your document contains multiple composite layers, it is advisable to open, work on, and close, one at a time.


Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: