Altium NEXUS Documentation

PolylineEnd

Created: June 11, 2016 | Updated: April 11, 2017

Parent page: CAMtastic Commands

The following pre-packaged resource, derived from this base command, is available:


Applied Parameters: None

Summary

This command is used to end placement of the current polyline at the last placed vertex point.

Access

This command is accessed from the CAMtastic Editor, when placing a polyline, by right-clicking and choosing the End command from the context menu.

Use

After launching the command, placement of the current polyline will be terminated at the last placed vertex point. You will remain in polyline placement mode. Continue placing further polylines, or press Esc to exit.

 

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: