Altium NEXUS Documentation

SelmenuCross

Created: June 11, 2016 | Updated: April 11, 2017

Parent page: CAMtastic Commands

The following pre-packaged resource, derived from this base command, is available:


Applied Parameters: None

Summary

This command is used to select design objects within a user-defined area. The objects do not have to be wholly inside the defined boundaries of the area.

Access

This command can be accessed from the CAMtastic Editor by:

  • Choosing the Edit » Selection » Crossing Window command from the main menus.
  • Clicking the  button, on the Miscellaneous Tools drop-down () of the Utilities toolbar.
  • Using the Alt+C keyboard shortcut.

Use

After launching the command, the cursor will change to a crosshair and you will be prompted to select the first corner of the selection area. Position the cursor and click to anchor this corner. You will then be prompted to select the second corner. Move the cursor to size the selection area and click to anchor this corner. All objects that fall completely, or partially inside this defined area, will become selected.

Tips

  1. You must be in editing mode (carrying out an editing operation), before this command will become available.
  2. Objects will only be selected if the Add selection mode is enabled.
  3. Using this command on an existing selection, and with the Remove selection mode enabled, will cause all objects in the defined area to become deselected.
  4. The objects added/removed will depend on the selection modes enabled - Flash/Point and/or Draws.

 

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: