Altium NEXUS Documentation

ToolsMillViewRetract

Created: June 11, 2016 | Updated: April 11, 2017

Parent page: CAMtastic Commands

The following pre-packaged resource, derived from this base command, is available:


Applied Parameters: CommandMode=NC

Summary

This command is used to toggle the display of retract point symbols for rout paths in the current document. A retract point is the exit point for the routing tool, after routing a path in the design.

Access

This command is accessed from the CAMtastic Editor by choosing the View » Display Symbols » Retract command from the main menus.

Use

After launching the command, the retract point symbols on rout paths will either appear, or disappear, depending on their current visibility status.

 

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: