Altium NEXUS Documentation

CAMTASTIC_Cmd-ToolsNetListCleanNetsToolsNetListCleanNets_AD

Created: June 11, 2016 | Updated: April 11, 2017
This documentation page references Altium NEXUS/NEXUS Client (part of the deployed NEXUS solution), which has been discontinued. All your PCB design, data management and collaboration needs can now be delivered by Altium Designer (with Altium Designer Enterprise Subscription) and a connected Altium 365 Workspace. Check out the FAQs page for more information.

Parent page: CAMtastic Commands

The following pre-packaged resource, derived from this base command, is available:


Applied Parameters: None

Summary

This command is used to clear all nets from the current document, essentially flushing the previously extracted netlist.

Access

This command is accessed from the CAMtastic Editor by choosing the Tools » Netlist » Clean All Nets command from the main menus.

Use

After launching the command, all net information will be removed.

Tips

  1. You can verify that all nets have been cleared from the CAM document using the CAMtastic panel. You will see that the Nets tab will be empty.

 

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: