Altium NEXUS Documentation

PolylineArcMode

Created: June 11, 2016 | Updated: April 11, 2017

Parent page: CAMtastic Commands

The following pre-packaged resource, derived from this base command, is available:


Applied Parameters: None

Summary

This command is used to change from drawing lines to drawing arcs, while placing a polyline object in the current document.

Access

This command is accessed from the CAMtastic Editor, when placing a polyline, by right-clicking and choosing the Change to Arc command from the context menu.

Use

After launching the command, the current mode for polyline placement will change to arc, and an arc segment will appear extending from the last vertex point placed.

Tips

  1. At least the first two vertices must have been placed in line mode when defining the polyline, before you can change to arc mode.

 

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: