Altium NEXUS Documentation

InfoMinAnnularRing

Created: June 11, 2016 | Updated: April 11, 2017

Parent page: CAMtastic Commands

The following pre-packaged resource, derived from this base command, is available:


Applied Parameters: None

Summary

This command is used to interrogate the annular ring of the selected pad.

Access

This command is accessed from the CAMtastic Editor by choosing the Analysis » Query » Minimum Annular Ring command from the main menus.

Use

First, ensure that the CAMtastic panel is visible.

After launching the command, the cursor will change to a pointing hand and you will enter annular ring query mode. Simply position the cursor above the pad whose annular ring you wish to query, and click. Values for the X and Y annular ring distances will appear on the Info tab of the CAMtastic panel.

Continue interrogating further pads, or press Esc to exit annular ring query mode.

Tips

  1. All measurement information uses the current units for the workspace - either inches or millimeters. Units can be changed either from the CAMtastic panel, or the CAM Editor - Drawing Modes page of the Preferences dialog.

 

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: