Altium NEXUS Documentation


Created: June 11, 2016 | Updated: April 11, 2017
This documentation page references Altium NEXUS/NEXUS Client (part of the deployed NEXUS solution), which has been discontinued. All your PCB design, data management and collaboration needs can now be delivered by Altium Designer (with Altium Designer Enterprise Subscription) and a connected Altium 365 Workspace. Check out the FAQs page for more information.

Parent page: CAMtastic Commands

The following pre-packaged resource, derived from this base command, is available:

Applied Parameters: CommandMode=NC


This command is used to convert a closed boundary rout path to a rout circle, within the current document.


This command is accessed from the CAMtastic Editor by choosing the Rout » Convert Lines to Circle command from the main menus.


After launching the command, you will be prompted to select a closed boundary. Simply position the cursor over part of the boundary for the rout path you wish to convert to a circle and click - the closed boundary rout path will be replaced by a circle, whose center point is defined as the center of a bounding rectangle that would enclose the closed boundary shape, and whose radius is defined by the horizontal distance from that center point to the edge of the bounding rectangle.

Continue converting further closed boundary rout paths to rout circles, or right-click, or press Esc, to exit.


  1. If the rout path is a closed boundary made up of line segments, these segments must first be joined before the command can be successfully used.


Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: