Altium NEXUS Documentation


Created: June 11, 2016 | Updated: April 11, 2017

Parent page: CAMtastic Commands

The following pre-packaged resource, derived from this base command, is available:

Applied Parameters: CommandMode=NC


This command is used to run the Rout Pads Options dialog, from where you can define options to be observed when pads are encountered along a rout path.


This command is accessed from the CAMtastic Editor by choosing the Rout » Rout Pads Options command from the main menus.


After launching the command, the Rout Pads Options dialog will appear. Setup the available options as required.


  1. By default, round pads will be converted to drill points.


Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: