Altium NEXUS Documentation


Created: June 11, 2016 | Updated: April 11, 2017
This documentation page references Altium NEXUS/NEXUS Client (part of the deployed NEXUS solution), which has been discontinued. All your PCB design, data management and collaboration needs can now be delivered by Altium Designer (with Altium Designer Enterprise Subscription) and a connected Altium 365 Workspace. Check out the FAQs page for more information.

Parent page: CAMtastic Commands

The following pre-packaged resource, derived from this base command, is available:

Applied Parameters: None


This command is used to toggle the display of the Extents Box. This box is used to display the drawing extents within the main design workspace.


This command can be accessed from the CAMtastic Editor by:

  • Choosing the View » Views » Extent Box command from the main menus.
  • Using the Shift+E keyboard shortcut.


After launching the command, the Extents Box will either be displayed or not, depending on its current display status. When displayed, the box boundaries are dotted red lines.


  1. The CAMtastic Editor allows 260 by 260 inches for design work. When you move the cursor outside the bounding edges of the Extents Box, you will see "Out of Limits!" in the Coordinates field in the CAMtastic panel.


Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: