Altium NEXUS Documentation

CAMTASTIC_Cmd-ToolsPadsToolsPads_AD

Created: June 11, 2016 | Updated: April 11, 2017
This documentation page references Altium NEXUS/NEXUS Client (part of the deployed NEXUS solution), which has been discontinued. All your PCB design, data management and collaboration needs can now be delivered by Altium Designer (with Altium Designer Enterprise Subscription) and a connected Altium 365 Workspace. Check out the FAQs page for more information.

Parent page: CAMtastic Commands

The following pre-packaged resource, derived from this base command, is available:


Applied Parameters: None

Summary

This command is used to remove isolated and stacked pads from all internal signal layers in the current document.

Access

This command can be accessed from the CAMtastic Editor by:

  • Choosing the Tools » Pad Removal command from the main menus.
  • Clicking the  button, on the Fabrication Tools drop-down () of the Utilities toolbar.

Use

After launching the command, an information dialog will appear, providing a summary of the isolated and stacked pads that were detected on all internal signal layers found in the current document. After clicking OK, the indicated total number of pads will be removed.

Tips

  1. One or more layers in the current document must be of type Internal in order for this command to be used.
  2. If using Altium NEXUS's PCB Editor to generate the Gerber files, disabling the Include unconnected mid-layer pads option - on the Layers tab of the Gerber Setup dialog - will effectively provide the same action as this command.

 

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: